Den-Mat Sapphire Instrukcja Operatora Pobierz pdf (Strona 3)

Important Start-up Instructions

(Follow these instructions prior to using the system)

1. Attach the AC Power Cord to the power inlet on the Sapphire Plus light source and plug into AC outlet.

2. Install the Curing, Lesion Detection or Soft Tissue Management (STM) device into front panel receptacle

(black adapter insert must be removed to install STM). Make sure the device is ﬁrmly inserted all the way into

the receptacle before turning on the power. If the device is not installed correctly the system display will show

“no HP” meaning No Hand Piece is detected.

3. When using the built-in light meter, the handpiece should be held in the position as indicated in the illustration.

The tip should be centered inside of the aperture. Positioning the tip differently may result in reduced light

intensity values.

4. Do not saturate the controller keypad area with disinfectant or other liquids. Wipe the keypad surface with a

damp towel and dry completely.

5. If the lamp access plate on the bottom of the system is removed to check

the lamp, make sure that it is replaced correctly. The corners of the plate

must ﬁt into the outline of the cutout area and not rest on top of the edges of

the surrounding metal. When installed properly all surface areas are even with

each other. If the access plate is misaligned, the lamp will not activate. If the

access plate is misaligned the system will show “Locd” meaning system is

Locked and the lamp will not activate.

Dangerous Voltage

Attention: consult accompanying documents

Attention: may be hot

Protection Class BF, Insulation Class 1

Alternating Current

Fuse

Enclosed Equipment Protected

Against Dripping Water

Hazard, High-Intensity Light

(applies when Curing/Whitening

Handpiece is attached)

DO NOT use in the presence of

ﬂammable substances

Laser Radiation – Avoid eye

or skin exposure to direct or

scattered radiation (applies

when Laser Handpiece

is attached)

1 2 3 4 5 6 7 8 ... 23 24

Brak uwag

Den-Mat Sapphire Instrukcja Operatora Strona 3