Den-Mat Sapphire Instrukcja Operatora Pobierz pdf (Strona 13)

Bleach (Whitening) Mode

After the system power is switched ON ( I ), use the RIGHT arrow key to advance to the BLEACH mode. Or, if

in the CURE mode, disconnect the light guide to reset the system. use the RIGHT arrow key to advance to the

BLEACH mode.

The indicator light next to BLEACH on the control panel will turn on. The display windows will show “Pr Hi”

(power high). use the DOWN arrow key to adjust power down in 5% increments.

Use the RIGHT arrow key to change to the bleach timer. The default timer is 60 minutes. The timer can be

adjusted by using the UP and DOWN arrow keys on the CONTROL WHEEL.

To adjust the power output, press the DOWN arrow key on the CONTROL WHEEL to reduce the power and

the UP arrow key on the CONTROL WHEEL to increase power. Lower power is useful for single tooth whitening

using the 12 mm curing probe to control heat. High power is used with the Whitening Crystal.

Start the lamp by pressing the ACTIVATOR button on the handpiece or the START/STOP button on the control

panel. Stop the lamp by pressing the ACTIVATOR button or START/STOP again.

BLEACH

Bleach 60 minutesPower High

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Brak uwag

Den-Mat Sapphire Instrukcja Operatora Strona 13